Official distributor in Russia and CIS countries
Mobile ultrahigh-pressure pumping station
Ultrahigh-pressure pumping station for chemically active, aggressive, high-purity liquids supply to the process
Model range of mobile units for hydraulic testing KGF-TEST M1 series
Ultrahigh pressure mobile pumping station KGS-TEST-M1-1200-120- XL for the supply of chemically active, aggressive, high-purity liquids to the process in the pressure range of 400-1200 bar.
Installation composition:
- Hydraulic pump with pneumatic drive, model 5L-DD-120
- Power elements of the pneumatic pump drive:
- Through fitting for connection to the pneumatic network – mounting on the side panel
- Mechanical air filter-oil separator
- Pressure reducer – mounting on the control panel
- Start-stop/pump speed control valve – mounting on the control panel
- Low pressure line:
- Through fitting for connection to the water supply – mounting on the side panel
- Mechanical suction filter ½" 10 microns, 7 bar
- High pressure line:
- Mechanical pressure gauge on discharge: front flange for panel mounting, dial 160 mm, scale 0-1600 bar, accuracy class 1%, NPT fitting, measuring range (25-75%): 400-1200 bar
- Discharge fitting – mounting on the side panel
- Pressure relief valve without protection from mechanical contamination, outlet to the drain fitting
- High pressure tubes and fittings, pressure class not less than 1380 bar
- Installation body: welded semi-open/closed stainless steel frame. steel with main control panel and side panels
- All controls and fittings are placed on the panel
- Intelligent design of control panels, signatures in Russian
| Pump Model | 5L-DD-120 |
| Number of pumps in the unit | 1 |
| Drive Type | pneumatic |
| Type of hydraulic part | two-plunger |
| Type of pneumatic part | two-piston |
| Multiplication factor | 120 |
| Range of discharge operating pressures | 120-1241 bar |
| Maximum allowable pressure in the pneumatic network | 10.3 bar |
| Recommended pressure in the pneumatic network | 5-10 bar |
| Minimum pressure in the pneumatic network | 2 bar |
| Feed per cycle | 29.2 ml/cycle |
| Efficiency | 0 - 1.8 (6.5) l/min |
| Maximum permissible fluid pressure at the inlet fitting of the installation | 7 bar |
| Recommended fluid pressure at the inlet fitting of the installation | 3 bar |
| Minimum fluid pressure at the inlet fitting of the installation | atmospheric |
| Operating temperature range of the pneumatic actuator | -12 °C ... +65 °C |
| Operating temperature range of the hydraulic part | +3 °C ... +40 °C |
